![]() ![]() That being said you might be able to program a button to activate open when pressed and to also activate the same function on release. The only things I get from what is stated is that if you press to open - you press the button again to stop it (not a true move up move down motion). That tells me that it appears your UAP will not allow for the individual movements that you are looking to achieve. The UAP enables you to control the light of the supramaticĬheck whether the door is totally closed or totally open, light status? ![]() I am an electronics amateur and can't figure out based on the schematic below if that is correct?Ĭurrently I send a 0.5 impulse through when you press open/close in the home automation system - as that's similar to how the garage door remote control works, but not sure this is correct. On the UAP it connects to input 10, 17, 15 and 23 where 10 + 17 is wired to one relay and 15 + 23 to another. The status (fully closed, fully open, mid drive) works perfectly fine, however I am having issues with the motion commands (move up, move down, stop), as they only work sometimes and in some directions - which is most likely due to me wiring it up incorrectly (however the guide linked above is not very specific about the wiring etc).Ĭurrently I use the Loxone Relay Extension (basically classic relays) through which I wired a cable on which I run 24V DC if the relay is on. ![]() I found this guide, which made the setup easier and I've setup everything accordingly. I own a Hörmann Supramatic 3 garage door opener and in my house I've also set up Loxone home automation system, so I decided to connect the opener to the automation system, so I can control the garage door remotely.įor that to work I needed to buy a UAP (universal adapter, meant for uses like these) and connect it to my Loxone miniserver. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |